STEYR CONTROL CENTER - SCC
Users manual
Z001071/0-00-061107_HH
Page 5 of 25
Installation
Dashboard/flush mounting
·
Select an appropriate place in your dashboard.
IMPORTANT: To avoid overheating of the SCC in direct sunlight ensure
enough air ventilation behind the SCC. There must be a space of at least
10cm/4inch behind the SCC.
·
Take the flush mounting template and check the dimensions before using it.
Dimensions may differ because of the printing or photocopying process.
·
Mark the positions for the four drill holes on the edges.
·
Drill the four holes
·
Mark the cut out from one drill hole to the next.
·
Check dimensions. Be sure not to cut out too large!
·
Cut out the rectangle
·
Attach the two mounting brackets type A on the SCC
·
Put the SCC into the cutting
·
Prepare mounting bracket type B: Screw the nut on the fixing screw screw the
fixing screw into the mounting bracket type B and screw the rubber spacer on
the fixing screw as far as it will go.
·
Attach the two mounting brackets type B on the SCC and screw them down on
the SCC with the four mounting screws. The rubber spacer should not touch the
dashboard so far.
·
Screw down the two fixing screws. When the rubber spacer touches the
dashboard turn on the fixing screw about two more revolutions. The required
torque is 0.8Nm. Do not over tighten the fixing screws! The rubber spacers
mustn't be pressed together more than 1mm (0.04 inch). Take care to leave a
gap between the front of the dashboard and the SCC.
·
Counter the fixing screw with the nut.
Summary :
· Cut out the rectangle · Attach the two mounting brackets type A on the SCC · Put the SCC into the cutting · Prepare mounting bracket type B: Screw the nut on the fixing screw screw the fixing screw into the mounting bracket type B and screw the rubber spacer on the fixing screw as far as it will go.
Tags :
scc,fixing,mounting,rubber,type,dashboard,two,out,cut,dimensions,screws,drill,four