Lighting Design Guide 230V
DOC. 4859
23
Module Installation
A licensed electrician, in accordance with all national and local codes, must mount the terminal
blocks and modules in a Crestron Automation Enclosure.
Terminal blocks are installed along the left side of single-wide enclosures and along the outside
edges (left and right sides) of double-wide enclosures. Modules are installed along the right side of
single-wide enclosures and side-by-side in the center of double-wide enclosures. When installing
modules and terminal blocks in a double-wide enclosure, be sure to invert units on the right side
so that they can be properly wired. Refer to the illustrations when considering the location of
terminal blocks and modules within an enclosure.
CAUTION:
This equipment is for indoor use only and needs to be air-cooled. Mount in a well-
ventilated area. The ambient temperature must be 0°C to 40°C. The relative humidity must be 0%
to 90% (non-condensing).
CAUTION:
Modules contains electrostatic sensitive devices (ESDs); unit must be handled from
metal chassis do not touch PC board or components.
NOTE:
Modules and terminal blocks must be installed into the lowest available spaces and
continue toward the top of the enclosure.
NOTE:
Modules are installed after the enclosure has been completely wired.
Single Width Enclosure Mounting
Module and associated terminal block installed in single width enclosure.
The PAC2 processor occupies the lowest module position.
Summary :
4859 23 Module Installation A licensed electrician, in accordance with all national and local codes, must mount the terminal blocks and modules in a Crestron Automation Enclosure. Single Width Enclosure Mounting Module and associated terminal block installed in single width enclosure.
Tags :
enclosure,modules,terminal,installed,blocks,enclosures,module,side,along,doublewide,right,note,left